Steering Tools
Available32 products
Vehicle steering tools include arm pullers, steering wheel lock plate removers, and pivot pin removers. Suspension level kits contain the tools needed to increase ground clearance while leveling the front end with the rear. Tools include tie rod adjusters to realign the vehicle, master ball joint separators to loosen the joints for removal, and torsion bar unloaders that clamp onto the frame of the vehicle. Coil spring compressors hold springs taut for easy removal or installation.
Steering Wheel, Pulley, Flywheel Pullers
These tools help pull steering wheels on most late model cars including domestic cars with or without collapsible steering columns. They also function as a standard 2/3-way puller for removing pulleys and small engine flywheels.
Tool Type: Unspecified
| Loading... | |||||||
Arm Puller
| Loading... | |||||||
Pump Pulley
| Loading... | |||||||
Rod Socket
| Loading... | |||||||
Steering Wheel, Pulley and Flywheel Puller
| Loading... | |||||||
Arm Pullers
Arm pullers help remove tie rods. These tools are one-piece cast or forged U-shaped pullers that lock over the steering arm or drag link. The center stud is then threaded into the tool to press the joint or tie rod out.
| Loading... | ||||||||
Puller Leg Sets
Puller leg sets remove bearings and hubs from the steering column. Each puller has a long bolt with a pointed tip on one end and a hex grip on the handle for turning by hand or with a tool. The claw legs are reversible for internal and extreme pulls, and may be adjusted using the nuts and bolts.
Wheel Puller
| Loading... | ||||||
Steering Pivot Pin Removers
These tools remove pivot pins from steering columns. Pivot pins allow the tilt housing to turn on the support stand for the steering column. The remover works on both tilt and telescoping steering systems.
Pin Remover
| Loading... | ||||||
Locknut Pin Removers
These make- and year-specific tools remove locknut roll pins from steering columns. The tool is inserted into the roll pin and the hammer slides the pins out.
| Loading... | ||||||
Tie Rod Tools
Steering tools help remove steering tie rods to make removal and re-installation of camber and toe equipment easier. Tie rod pullers can also press out worn bushings in the steering column for replacement.
Tool Type: Unspecified
| Loading... | ||||||
Inner Tie Rod Removal Set
| Loading... | ||||||
Inner Tie Rod Wrench
| Loading... | ||||||
Tie Rod/Pitman Arm Adjusting Set
| Loading... | ||||||
Universal Tie Rod Adjusting Tool
| Loading... | ||||||
Caster/Camber Tools
Caster and camber tools are gauges that help align wheels. These tools allow mechanics t adjust caster and camber to improve a vehicle's steering capabilities.
| Loading... | |||